Malware Protection

Print Friendly, PDF & Email

This feature helps you protect your system from threats such as spyware, adware, keyloggers, and riskware while you are connected to the Internet.

Configuring Malware Protection

To configure Malware Protection, follow these steps:

  1. Open Quick Heal AntiVirus Server Edition.
  2. On the left pane, click Protection and then click Malware Protection. Turn Malware Protection on.

    Malware Protection is enabled.

  3. To set further security measures for malware protection, click anywhere on Malware Protection and then set the following options.
    • Enable Adware detection: If you want to detect any adware, select this option. If you enable this option, further actions to be performed are displayed.
    • Select action to be performed when adware is found: Select one of the following actions to be performed when any adware is detected – Prompt, Repair, Skip.
Action Description
Prompt If you select this option, a message will appear when an adware is detected. The message will display the following options:

  • Allow: Click this button to allow the adware to execute.
  • Remove: Click this button to remove the adware. In case, the adware is not removed successfully, the adware is quarantined and will be cleaned in next Boot Time Scan.
  • Close: Click this button to close the message. The same message will keep appearing until you take an action.
Repair Select this option if you want to repair a file. If an adware is found in a file during scan, the file is repaired. If the file cannot be repaired, it is quarantined and will be cleaned in the next Boot Time Scan.
Skip Select this option if you want to take no action on a file.
Was this page helpful?

Leave a Comment